IC Chip Extractor Machine Clip For ROM Extraction Removal Puller Repair Hand Tool DIP Encapsulation Extraction Anti-static

PLCC package special IC chip ROM extractor, extract the motherboard BIOS special extractor designed for PLCC. The body is made of stainless steel, which is suitable for PLCC of different specifications and sizes.
1. The PLCC can be easily taken out of the substrate without damaging any IC conductors. PLCC, PGA, PCLL, DIP packaged ICs can be pulled out from SOCKET or PCB.
2. Using a handshake method, pull the IC up steadily in the vertical direction (not forcibly pull up), so that the pulled out IC can get a complete PIN.
3. The densely arranged ICs can be pulled out directly without touching other ICs.
4. ICs of different sizes within 5.5cm of the contact surface can be pulled out in a very short time, the operation is simple and labor-saving.
To remove the PLCC chip, if you use a flat-blade screwdriver, because there are other components around it, it is very difficult to remove. If there is no special removal clip, it is difficult to remove. Improper operation may cause damage to the socket or chip, or even break the chip. , Broken foot. The chip pick-up clip we prepared for you can be used directly on the board to facilitate the pick-up of PLCC packaged chips. It is a good tool for picking up and picking up various chips and integrated blocks. It is used for motherboards, single-chip computers, and programmers.
This kind of pull-out clamp for PLCC chip is more suitable for easy pull-out of PLCC chip. If you need to extract DIP packaged chips, we recommend another "DIP chip extractor", which can be found in our shop under the category of "electronic tools, components".
The specific method of use is to insert the two pins of the pick-up and pull-out clip from the two notches of the chip socket respectively, and then hold the clip, and hold the clip with a little force, then the chip can be easily pulled out. For the PLCC packaged chip, due to its special package form, a dedicated chip picking clamp is used to operate it. Use the ROM extractor to clamp one corner and the opposite corner of the BIOS chip, press the extraction clamp, and pull the chip straight up from the socket. Note that the clamp must be the corner of the chip where the non-beveled corner is located, and the claw of the extractor should be as deep as possible into the socket. When removing the chip, you need to be very careful. Incorrect handling or improper force may damage the motherboard or the BIOS chip itself.