2800W Integral Induction Heater AC110-220V Input with Water Cooling and Air Cooling

Condition:New
Type:Logic ICs
Color classification:Main Crucible
This product is a low-power induction heater with AC 110V-220V power supply. It can be used for heating and quenching of small ferrous metal materials. The maximum temperature of 70 mL graphite crucible can reach 1600 degrees Celsius. It can melt iron, copper, gold, silver and aluminum easily.First: Product characteristics and functionsOneIt adopts the integrated metal shell design, which is convenient to use and carry, and has good heat dissipation.TwoIntegrated power supply to avoid complex wiring;ThreeThe heating ring is wrapped with heat-resistant and heat-insulating material to prevent short-circuit during heating, and the heating ring can be disassembled and replaced, and a specific heating ring can be customized.4.Integrate the internal water cooling circulating system to prevent the heating ring from overheating.FiveTwo high-power fans at the top are used for heat dissipation.SixThe current overload protection switch is added, and the protection circuit is tripped in time once overload occurs.SevenThe working parameters of the large LCD screen display system, including voltage, current, power, motherboard temperature and so on, can be easily switched between Chinese and English by one key.II: Product parametersOneShape size: length, width and height 380 * 140 * 210 (unit: mm);TwoSize of heating ring: 70 * 60 * 73 (inner diameter * outer diameter * high);ThreeInput voltage: AC110-AC220V 12A;4.DC working voltage: 48V (internal power supply voltage is meter display voltage);FiveMaximum DC operating current: 50ASixDirect heating of metallic iron at a maximum temperature of 800-900 degrees CelsiusSevenUse crucibles at a maximum temperature of 1600 degrees CelsiusIII: NoticesOneStart-up sequence should follow the first turn on the main power switch, wait a few seconds to see the fan and pump working properly and then watch the voltage and voltage display at about 48V before turning on the induction heating switch on the back. Do not operate errors, otherwise the main board will be burned directly and unprotected. Turn off the heating switch before turning off the power switch. If the shutdown is not in use for a period of time, the total power supply should be turned off after a minute of disconnection of the heating switch, so that the cooling system can cool the system and increase its service life.TwoWhen working, water cooling and air cooling must work at the same time. If any one of them does not work, the power supply should be disconnected immediately and the manufacturer should contact the solution.ThreeIf there are conditions for water cooling, cold water can be directly discharged into hot water without circulation, so the heat dissipation effect is better.4.For long-term use of crucibles, more crucibles should be prepared. Graphite heated at high temperature will react with oxygen to produce carbon dioxide and gradually consume the crucible.FiveWhen using, pay attention to the changes of various parameters of the display screen, especially the voltage and current and the temperature of the motherboard. Once abnormal is found, the power supply must be disconnected immediately.SixWhen high power is used, it is a normal phenomenon that the working noise of heat dissipation system will be relatively large.



?