Condition:New
Type:Logic ICs
Model Number:4000W
Supply Voltage:DC48V
This product is a small power induction heater with a DC48V power supply and a maximum current of 85A and a power of 4000W. It can be used for the heating and quenching of small ferrous metal materials. With the matching 70mL or 290ml graphite crucible, the maximum temperature can reach 1600 degrees Celsius. Easily melt iron copper gold Silver and other metals.
Note: The power supply isdisassemble power supply!! Please know.
One: Product Features and Functions 1. 2mm thickness PCB design, copper thickness 2OZ, large current, good heat dissipation;
2. 180mm 220V cooling fan;
3. The heating coil is wrapped with high temperature resistant thermal insulation material to prevent short circuits during heating, and specific heating coils are customized;
4. The input terminal uses a high-current power terminal, which can be directly connected to a dedicated 100A power meter;
5. Send the matching water pump for water cooling in the heating circle, and send the temperature sensor to monitor the temperature of the motherboard at any time;
Two: product parameters 1. Dimension: 220 * 180 * 150 (unit: mm)
2. Heating ring size: 70 * 60 * 73 or 105 * 90 * 90 (inner diameter * outer diameter * height);
3. Input voltage: DC48V;
4. Maximum power: 4000W;
5. Maximum DC working current: 85A
6. Direct heating of metallic iron with a maximum temperature of 800-900 degrees Celsius
7. Use crucible maximum temperature 1600 degrees Celsius
Three: matters needing attention 1. Users who only buy the motherboard but not the power supply must use their own power supply to ensure that the power supply can stably output more than 80A. Generally, two 50A communication power supplies are used in parallel.
2. The startup sequence should follow the power supply first, wait for a few seconds after the power supply is stable, and then connect the power supply between the power supply and the motherboard (recommended to use a 100A circuit breaker). Do not operate incorrectly, otherwise the motherboard will be burned directly. And unprotected. When shutting down, first turn off the switch between the motherboard and the power supply, and then turn off the power switch.
3. Water cooling and air cooling must work at the same time. If any of them does not work, you should immediately disconnect the power and contact the manufacturer for solutions;
4. If conditional water cooling is available, the cold water can be directly drained into the hot water instead of being circulated, so the heat dissipation effect is better;
5. For the long-term use of crucibles, you should prepare more crucibles. The high temperature heating of graphite will react with oxygen to generate carbon dioxide and gradually consume the crucibles;
6. Pay attention to the changes of various parameters of the display, especially the voltage and current, and the temperature of the motherboard. When you find any abnormality, you must immediately disconnect the power.
Host + heating coil (water pump) 
Host + heating coil + 70ml crucible 
Host + heating coil + 70ml crucible + dual power supply 
Host + heating coil + 150ml crucible 
Host + heating coil + 150ml crucible + dual power supply 
Use scene graph 
