8 level9 level electromagnetic gun FinishedDIY kit, integrated circuit ZVS module voltage 12V up to 450V with voltage display

8 level9 level electromagnetic gun FinishedDIY kit, integrated circuit ZVS module voltage 12V up to 450V with voltage display

Price:   $168.55

  • Model: ic0A248
  • Shipping Weight: 0.2kg
  • 9999 Units in Stock

(0 reviews)

Please Choose:

  • NEW
  • New connector
  • Used
  • Used connector
(complete orders today,deliverd around 26/04/2025)
  • Shipping time
    Shipping Worldwide.About 5-15 days.
  • means of transportation
    EMS,DHL,FEDEX,HK Post
  • Payment
    Paypal,T T,
  • Email us
    [email protected]
  • New Products
    5PCSUCC3802DTR UCC3802D UCC3802 Integrated Circuit(IC)Chip Brand New Original Authentic
    $2.36
    5pcs Power Switch Chip Bsp752r Silk Screen 752r Sop8 Brand New & Original Imported Spot
    $10.00
    5pcs Vn5772ak Vn5772 Patch Sop28 Car Computer Board Driver Chip Brand New Imported
    $3.71
    5PCS Original Tp61040dbvr Tp61040 SOT23-5 Printing Pho1 Boost Regulator Chip
    $0.85
    • Details
    • Reviews
    • Tags
    • FAQ
    Condition:New
    Type:Logic ICs
    Model Number:8 level


    8-level electromagnetic gun



    8 level ABS


    Instructions:

    1. Put the air switch in the off position

    2. Connect the power supply, pay attention to the positive and negative batteries, and the batteries are connected in series. If you don't understand, please Baidu. The battery is incorrectly connected and cannot work.

    3. Press and hold the small switch to charge the capacitor. (It is best to use a voltmeter, the charging voltage is within 420v) If there is no voltmeter, please control the charging time within 1.5s. Release the small switch after charging. The charging time should not exceed two seconds, otherwise the capacitor overshoot may swell or even explode.

    4. Close the air switch to complete the launch.

    5. Turn off the air switch to start the cycle test.

    ****note****

    1. The air switch and the small switch cannot be closed at the same time. If they are closed at the same time for a long time, the booster module may be damaged.

    2. Hazardous pressure, experiment with caution.

    3. Pay attention to the initial position of the steel ball, the steel ball is close to the coil, and the steel nail 1/4 is put into the coil. The other end is the injection end.

    Since the battery is not easy to transport, the product does not contain the battery on the picture, please know.Battery model 18650,please buy in your local.Thank you.