Purchase Tips:

Purchase options need to be purchased according to product testing requirements and test environment: shell installation is required, it is recommended to select adjustable potentiometer to lead external (left); no need for instrument housing installation, optional adjustable potentiometer welding board (middle) Long-term test use does not require frequent adjustment of aging parameters. It is recommended to select 3296W potentiometer welding plate to avoid changes in load parameters caused by external force touch or vibration (right)

• Product characteristics:

• The electronic components of this product are designed and manufactured by major well-known brand manufacturers, with low power consumption, good quality and high reliability. It is easy to operate, small in size and easy to assemble. With over-voltage, over-current, over-power, over-temperature protection, intelligent temperature control heat dissipation, with test status, measurement mode power-off memory. This product is widely used in various types of power supply testing or supporting a variety of related instruments and instruments measurement. One year warranty. Large stock, large quantity is preferred.

• technical parameter
• Load input supply voltage: DC 12-15V
• Load minimum standby power consumption: 0.3w
• Typical maximum power consumption of load: 6.0w
• Load rated power: 300W
• Load constant voltage accuracy: 0-80V/+0.2% 0-150v/+0.2% (RV09 single-loop adjustable potentiometer)
• Load constant current accuracy: 0-15A/+0.8%(RV09 single-loop adjustable potentiometer)
• Minimum on-load operating voltage (2.8V/30A)
• Load fan control: temperature control
• Load protection function: over-voltage, over-current, over-power, over-temperature protection 80 C
• Load module weight: 0.8kg
• Load Module Specification: 125 mm x long and 100 mm x 80 mm wide
• Load Radiator Technology: Non-Isolated Insulation

Introduction to Parallel Adjustable Load Module:
DIY300W is a parallel type adjustable load module. It is made up of two DIY150W load modules connected in parallel, so that the test power increases with the number of parallel connections, and the load pull current increases with the number of parallel connections. It operates in the same way as the DIY150W load module.
However, it should be noted that the load module without "potentiometer" is controlled by a potentiometer. Under normal circumstances, it is all green and does not need to be set separately.
Note: Reasonable wiring requires equal length to be connected to the tested terminal block of each load module. Please refer to the following figure (picture is provided by the customer, for reference only)