Freeshipping 6 level 7 level electromagnetic gun ABS pipe high voltage with display and Steel ball

Freeshipping 6 level 7 level electromagnetic gun ABS pipe high voltage with display and Steel ball

Price:   $149.09

  • Model: ic0A2593
  • Shipping Weight: 0.2kg
  • 9999 Units in Stock

(0 reviews)
(complete orders today,deliverd around 25/04/2025)
  • Shipping time
    Shipping Worldwide.About 5-15 days.
  • means of transportation
    EMS,DHL,FEDEX,HK Post
  • Payment
    Paypal,T T,
  • Email us
    [email protected]
  • New Products
    12pcslot CG2H40010F High Frequency Tube RF Microwave Tube
    $720.00
    TQP7M9104 6.5$ -30 pcs
    $195.00
    LED chip 20W 30W 50W AC 220V smart COB lamp beads LED lamp without driver DIY Lampada outdoor chip light floodlight spotlight
    $1.71
    AC COB Solderless Driverless LED 220V Chip 50W UV 395nm 110V Diode DOB LED No Driver 20W 30W for Curing Lamp Floodlight Chip COB
    $17.10
    • Details
    • Reviews
    • Tags
    • FAQ
    Condition:New
    Type:Logic ICs

    Instructions:

    1. Put the air switch in the off position

    2. Connect the power supply, pay attention to the positive and negative batteries, and the batteries are connected in series. If you don't understand, please Baidu. The battery is incorrectly connected and cannot work.

    3. Press and hold the small switch to charge the capacitor. (It is best to use a voltmeter, the charging voltage is within 420v) If there is no voltmeter, please control the charging time within 1.5s. Release the small switch after charging. The charging time should not exceed two seconds, otherwise the capacitor overshoot may swell or even explode.

    4. Close the air switch to complete the launch.

    5. Turn off the air switch to start the cycle test.

    ****note****

    1. The air switch and the small switch cannot be closed at the same time. If they are closed at the same time for a long time, the booster module may be damaged.

    2. Hazardous pressure, experiment with caution.

    3. Pay attention to the initial position of the ball, the steel ball is close to the coil, and the steel nail 1/4 is put into the coil. The other end is the injection end.
    Becausethe batteries is not easy to transport, the product does not contain the batterieson the picture, please know.Battery model is18650,please buy in your local.Thank you.

    6 level ABS