Huge Integrated full bridge DRSSTC Tesla coil Electronic lightning storm 70cm arc

Condition:New
Type:Logic ICs

• Product Name: integrated full bridge DRSSTC

• Voltage: 220 V, discharge voltage above 500 kV

• Current: 25A

• Size: 20 * 20 * 54cm

• Weight: 8kg

?Electrical parameters and precautions:?1. Do not change the power supply voltage and power without permission?2. It is forbidden to connect wires without permission?3. Please operate carefully according to the operation requirements?

Original design intention

? ? ?This Tesla is the first full-bridge Tesla in our store. It has higher power and better viewing effects. At the same time, we try to reduce the operation steps as much as possible. It is really simple and convenient, and it does not require professional skills. use. At the same time, our product does not require a grounding wire, eliminating the inconvenient grounding problem.?? ? ? In addition to adopting the full bridge for the first time in the circuit, the drive is also an original dual-totem phase-shifted drive, which achieves low delay, high efficiency, and effectively prevents the explosion of tubes.?? ? ?The diameter and length of the coil are accurately calculated, which is not only visually beautiful and excellent in texture, but also the resonance frequency is accurately fixed to 200kz. Use 0.2mm oxygen-free copper enameled wire to reduce resistance and heat generation. Can meet the requirements of long-term use?? ? ?The arc extinguishing module has its own battery and does not need to be connected to a charger or usb for power supply. The volume is only two 18650 size, and the operation is simple and convenient at a glance.

◆Dual totem phase shifting driver board-low delay, high efficiency, protect IGBT◆Full bridge power circuit◆Optical fiber signal transmission-long distance, anti-interference◆Drive arc extinguishing isolation design-safe and easy to use◆No ground wire design-small size, strong structure, easy to carry◆22v power supply directly◆70m arc discharge distance◆35mm audio interface

Matters needing attion

Please read the following carefully before buying?★For the sake of transportation safety, we will remove the coil and the equalizing ring when shipping. Please assemble it according to the instructions after receiving it, otherwise you will be responsible for all damages. (The installation is very simple, but you must operate as required)?★Do not directly touch the coil or equalizing ring at any time after the product is powered on?★The safe distance for product use is at least 2-3M. For patients with heart disease or with a pacemaker, please keep the distance more than 8m?★It is recommended to pause for a period of time to cool the product after continuous high-power use for about 10 minutes. If it is not high-power, you can extend the time of each use.?★Ensure that the arc extinguishing potentiometer is at position 0 when opening or closing

Use method◆Firstly, assemble the coil and equalizing ring according to the instructions, just simply tighten a few nuts.?◆Fix the discharge needle at the top of the equalizing ring.?◆Connect the arc extinguishing module and main body of the product with optical fiber line.?◆Open the arc extinguishing module and check whether it is working properly. If it works, turn the knob counterclockwise to the end, and then turn off the arc extinguishing.?◆After connecting the 220 power supply to the main body, it can be used, and the safety distance of the equipment is more than 2-3m.?◆Adjust the frequency and knob to reach the required arc length