Condition:New
Type:Logic ICs
Supply Voltage:220V

Can only play square wave music, normal music will be burned !

Design original intention

Ordinary drsstc needs to connect multiple power sources, as well as fiber optic cables and ground cables. Ordinary players may not fully understand or operate normally for a while and a half, resulting in product damage or improper use.

Our product is based on simplicity. The whole operation is very simple. It only requires one socket and one connector. No fiber optic cable, no ground wire, it can be said that it is the easiest to operate in similar products, and it can be used directly without ground wire, which greatly facilitates teachers' class exhibitions.
Show or live in high-rise buyers without ground.

It does not require multiple power supplies to supply power at the same time. It only needs one plug to be plugged into the socket to use.

No optical fiber connector, no optical fiber cable, reducing product costs and increasing use experience.

The arc length of the product is more than 20cm, and it supports music effects. It can directly play square wave music, and the arc can change to different arc sizes as the music rhythm changes.

The whole product is small and compact, only 1/2 of its counterpart, and the product is not yet two foam high, which is convenient to carry.

◆ Coaxial cable signal transmission
◆ Drive arc extinguishing isolation design
◆ Groundless design
◆ 220v power supply
◆ 20xm arc discharge distance

◆ 3.5mm audio interface

Matters needing attention

★ Do not touch the coil or grading ring directly at any time after the product is powered on.
★ The safe distance of the product is at least 0.5m, and it is recommended to watch from a distance of more than 1m.
★ When turning on or off, make sure the potentiometer is at 0 position.

Use method
◆ Plug the aviation plug into the base of the product first, and tighten the nut on the outer ring to prevent it from loosening.
◆ Place the discharge needle on the top of the pressure equalizing ring of the product, and the top end can extend 2-3cm.
◆ Place the cables flat and straight, do not overlap or knot, try not to suspend the cables.
◆ Finally, turn the potentiometer to the lowest counterclockwise.
◆ Plug the plug into the socket.
◆ When the light is off, it is in music mode. In music mode, the mobile phone or other players need to be in the playing state, and then use the audio cable to connect the audio port on the side of the knob and the audio port of the mobile phone.
◆ When the light is on, it is normal mode. You can directly turn the knob to adjust the arc size.
◆ Turn off the potentiometer of the product before turning it off.