Mini SGTC Solid State Tesla Coil Magnetic Storm Coil Artificial Lightning Experimental Teaching Toy High-tech

Condition:New
Type:Logic ICs

Design intention

Tesla COI1 is a kind of transformer (resonant transformer) operating on the principle of resonance. It was invented in 189 by Nicola Tesla, an American business scientist. It is mainly used to produce ultra-high voltage, low current and high frequency AC power. The Tesla diagram consists of two (sometimes three) coupled resonant circuits. Tesla coil is hard to define, Nikolai

Tesla has tried out a large number of various line graph configurations. Tesla uses these diagrams for innovative experiments, such as electrical lighting, fluorescence spectra, parent rays, high frequency AC current phenomena, electrotherapy and radio energy transmission, transmitting and receiving radio signals.

SGTC=Spark Gap Tesla Coil

"Tesla coil belongs to sgtc. Because the structure and principle are relatively simple, so it is also a beginner at this stage.

The principle of traditional Tesla coil is to use a transformer to boost the common voltage, and then charge the resonant capacitor of the primary LC circuit. When it is charged to the discharge threshold value, the spark gap is discharged and connected, and the primary circuit has series resonance to provide enough high excitation power to the secondary coil. Secondly, it is equal to the frequency of the secondary LC circuit to make the inductance of the secondary coil and the distributed capacitance have series resonance At this time, the discharge terminal voltage is the highest, so you can see the lightning. To put it more popularly, it is an artificial lightning generator.





Matters needing attention:


★The product cannot change the power supply voltage and power by itself.


★It is strictly forbidden to connect wires without authorization.


★Long-time work will produce some odorous radon, please pay attention to ventilation.


★Be sure to connect the ground wire before working and powering on.


★Hands can be approached, but touching the arc is not recommended.


★Do not touch the mold capacitor and the 3 copper ball electrodes immediately after use, as there is residual electricity inside, be careful of electric shock.