Plasma loudspeaker plasma sound plasma loudspeaker Mini Tesla coil

Ultra-large radiator, long-term use of heat is also very small, PCB basically does not need fan heat dissipation. However, the high-pressure pack will be hot in ten minutes, so it is not suitable to work continuously for a long time. If you want to work continuously, it is better to add a fan to heat the high-pressure package.

Copper wire discharge electrode needs sharpening, which can effectively reduce noise. There is no obvious difference between the positive and negative poles in which effect is the upper one and the lower one.

Exclusive design of high pressure pack mounting base, high pressure pack does not need to lie down on the table. This is not only for the sake of beauty, but also to prevent needle pins of high-voltage packages from unnecessary danger to discharge of other objects.

Exclusive design of discharge base, no longer have to worry about finding the right discharge electrode, nor need to use ugly radiator to make up.

Exclusive custom GDT, no need to wrap magnetic rings, easy and convenient, reliable and stable performance.

Debugging instructions:

103 potentiometer regulates duty cycle and increases clockwise. The larger duty cycle, the higher the heat of mos. The duty cycle can be adjusted to the ratio of the figure above. After installing the circuit, it is almost the same to twist 4-5 turns with a screwdriver along the pointer.

203 potentiometer adjusts frequency and increases clockwise. Adjust to about 30 kHz, install the circuit and twist 1-3 turns counterclockwise with a screwdriver.

Package description

[Full set of components]Including the drive board and all the above components, high-voltage package (with base), power board, discharge base and audio cable, need to be self-assembled.

[Full set for hand use]Including a full set of accessories, has been installed and debugged, you can use it when you get your hands connected.