Condition:New
Type:Logic ICs
In this test, the maximum power is close to 1600W and the maximum current is 35A. This product is in
It can work continuously for hours under the condition of good heat dissipation.
Our newly developed 4 tube high power ZVS upgraded version has the highest voltage of 54V and the maximum power of 1800W. This is another half of the ZVS induction heating power, which is the same as the one used in this shop.
Be careful:
The heating ring has different specifications, and the default 40mm inner diameter. Heating the metal with different sizes and materials with different heating rings, consult the shopkeeper for details.
Package 1 includes:
Finished circuit + copper tube + fan + pump + water pipe + communication power + air switch (use directly ,need to wire yourself)
Package 2 contains:
Finished circuit + copper tube + fan + pump + water pipe + communication power + air switch + crucible.(use directly ,need to wire yourself)
The circuit is powered by high-power communication power supply, and the power supply is 48V 3000W.
Pumps and adapters:
Crucible:
The figure below uses 75 mm inner diameter heating ring to heat 40 mm diameter iron rod. The temperature exceeds the range of my thermometer gun. It is estimated that the temperature is over 700 degrees.
The circuit uses two large power fans to dissipate heat and work for a long time.
【Instructions】
1. Fix the copper tube to the copper post of the circuit board and tighten the screws.
2. The water pipe is cut into three sections, connected to the water pump, copper pipe and water storage tank, and the water pump is connected to the power supply device.
3. Fix the fan with copper post. Insert the fan plug into the [fan] interface of the circuit board. If there is no plug, directly connect the red and black wires of the fan to the output of the power supply [+] [-], if it is a four-wire fan. Only red and black lines are connected, and the yellow and blue lines are not connected.
4, power wiring. The red thick wire is connected to the positive output of the power supply [+], the blue line is connected to the negative [-], and the red line is cut into two, and the middle is opened. The power cord with plug is connected to brown [L] blue [N] yellow green to [ground].
5. When the power is turned on, it must be disconnected. The power supply fan starts to rotate for ten seconds before it can be closed.
6. There is a [control] interface on the circuit board. The two wires can be connected to relays or small switches to control circuit heating. When not heating things, disconnect them, or the board can be powered, but the two wires of this interface should be disconnected, otherwise the board will heat up.
Template protection code
Template protection code
Template protection code
Template protection code
