Condition:New
Type:Logic ICs
Tip: Customers who need to change the Anderson plug must keep the original output cable length, solder the cable from the clamp, and then install the Anderson! Do not allow the output line to be arbitrarily modified and thickened, lengthened, shortened, etc., which may cause large current errors or even damage.
The product is continuously improved and upgraded, and the appearance and adjustment are also perfected, but the physical parameters remain unchanged! The latest version will be shipped. Without notice!
Use power supply model: DELLC2100.
Input voltage: AC 100v/110v --220v/250v (Taiwan customers have verified to use with confidence)
Input power: 750W-800W
Output voltage: DC constant voltage meets 11V-14.8V (suitable for 3 strings of ternary and 4 strings of lithium iron phosphate)
Output current: DC constant current meets 1-52A adjustable. (Only constant current and constant voltage can be used as charger)
Protection mode: After the positive and negative poles are short-circuited, the output is stopped. (Turn the current knob to the minimum to the off state, and then restart it to recover)
Appearance size: length 24CM*width 8.5CM*height 6.6CM.
Weight: 1.2KG.
Standby power: about 11W.
Cooling method: air cooling (built-in cooling fan, with the increase of temperature, the speed increases)
Included accessories: With two positive and negative wires and clips, (the power input wire needs to be prepared by yourself) The output wire uses 80A high-quality silicone wire.
Note: (Important things should be repeated three times!) The positive and negative poles of the battery must not be reversed (red positive and black negative), and the reverse connection will be broken if it is connected! Reverse connection will be broken, no warranty! Reverse connection will be broken , No warranty!
Instructions:
The first step: Do not connect the battery to the charger, turn on the power, adjust the voltage knob to adjust the voltage, refer to the voltage display at the top of the display, (four strings of lithium iron batteries 3.65v*4=14.6V, three strings of polymer batteries 4.2v *3=12.6V), adjust to the voltage you need.
Step 2: Adjust the current to the minimum. After connecting the battery, adjust the current from small to large, and then adjust it to the current you need. (During the charging process, it is not allowed to adjust the voltage knob, otherwise there will be overcharge or undercharge)
If the voltage is displayed, the voltage you set, the current becomes zero, and it is already full.
Precautions for charging lead-acid batteries:
Lead-acid batteries do not support high-current charging, and should be charged with 1/10 of the capacity. For example: a 100A lead-acid battery needs to be charged with 10A current! The time must be 8-10 hours. If the time is too fast and the current is too large, the battery will be damaged. The charging voltage of lead-acid batteries is around 14.4 volts. The voltage is slightly different depending on the manufacturer of the battery. The instructions on the battery label shall prevail!
Note: The product is handmade, and the appearance may be slightly scratched, please be aware!
