Single-phase three-phase motor equipment start times counter and running time counting timer Current detect timing

Switch detect: Switch Contact Close Start Timing Count

Current detect: Detection current count (please note equipment power)

■Basic features

●Record the total operating time and the number of starts of the electrical equipment, with high accuracy and good stability

●Detecting whether the electrical equipment is running can be detected by detecting current or starting contacts

●Automatically start recording time and number of times when the device is started plus 1, and keep the record when the motor stops

●The recorded time and number of times can be automatically saved, will not be lost after power failure, can be locked and reset is not allowed

●The detection circuit is easy to install, no need to change the original circuit on the motor equipment

●The recorder has preset value settings, and has relay OUT alarm output for over time or over number of times

●Built-in multiple timing ranges, suitable for 0.01 second-9999 hours, count of times 0-9999

●The recorder shell adopts a standard embedded case, which is simple and convenient to install

●Outer dimensions: height 48×width 48×thickness 80mm, installation opening size height 45×width 45mm

■Input wiring

●Use the detector to detect the running current of the motor equipment to determine whether the motor equipment is running. This method is convenient and reliable. The specific wiring is as shown in the figure below; please mark the approximate power of the electrical equipment or the approximate current during operation when you purchase it, and it will be matched when shipped. Good corresponding current detector.

●To determine whether the electrical equipment is running, you can also start the contact of the controller through the electrical equipment, the specific wiring is as follows:

■Function selection

The switch contact is closed to start timing counting: use the contact closure to time, and wire according to the contact wiring method

●Detection current counting: It is equipped with a current detector at the time of shipment, and it is connected according to the current detection method