XDS110 upgrade MSP432 serial port programming and debugging emulator burner full-function board enterprise version CC2640 CC1310

Product description:

The XDS110 is a new debug probe (emulator) for TI's embedded processors. The XDS110 replaces the XDS100 series while supporting a wider range of standards (IEEE1149.1, IEEE1149.7, SWD) in a single pod. Additionally, all XDS debug probes support core and system traces in all ARM and DSP processors that have an embedded trace buffer (ETB). The XDS110 is connected to the target board via a TI 20-pin connector (with multiple adapters for TI 14-pin, and ARM 20-pin) and to the host PC via USB2.0 High Speed (480Mbps). It also provides two additional connections:

● Auxiliary 14-pin port connector supporting EnergyTrace?, one full-duplex UART port.

● It supports USB2.0 high-speed interface, the theoretical speed reaches 480M/s, and the simulation debugging is carried out through the 14P/20P interface.

● Supports Code Composer Studio (CCS) V7/V8/V9/V10 and higher or IAR.

● It can be used for operating systems such as Win7/WIN8/WIN10.

Product Features:

• USB2.0 high-speed interface, up to 480Mbit/s

• Dual output level shifter chip (double buffer)

• USB side self-recovery insurance protection to protect your computer

• JTAG side electrostatic chip protection, anti-static ±15KV, stable and reliable

• Support power outage detection

• Support adaptive clock

• Support JTAG reset, wait and reset boot mode

• Support power-on reset boot mode

• Support a variety of FTDU device drivers

• Supports adjustable TCLK clock

• Support 1.8V~5 V JTAG voltage standard

• Support TI standard 14 PIN JTAG interface

• Support TI standard 20 PIN JTAG interface

• Supports 2-wire cJTAG interface to simplify connection to target boards

• Driver-free, plug in the emulator and automatically recognize it

• Support high-speed USB code download

• FLASH online emulation supporting DSP

• Faster emulation and download speeds

• Support CCSV7 and above, the new version CCSV10 is supported

• Support IAR for ARM V7.5 and above

• Support Flash Programmer2 programming software

• Support uniflash independent programming software,

• Support SmartRF Studio configuration software

• Support Win7/Win8Win10 and other operating systems

Supported chips List:

CC1310 programming:

CC2640 programming:

C2JTAG wiring method:

4-wire JTAG wiring:

Packing List:

Anti-static packaging：

1. 1 XDS110 emulator

2. 1 high-grade USB2.0 high-speed cable

3. 1 high-grade imported 14/20P JTAG color cable