Brand Name:icchipcn.com
Condition:New
Type:Voltage Regulator
Product synopsis: this module for ignition coil transformer after making circuit component of high pressure/modules/high voltage generator, can make the student science experiment/electronics/anion generator/small science produced when high voltage source is used, the module using the tesla coil principle, output high voltage pulse, small volume, high efficiency, discharge intensity.
Product name: High voltage generator
Model: 800
Volume: length 40mm width 40mm thick 18mm
Voltage: input DC3.7-6V, output DC200KV
Current: input 4A, output 0.005a
Line length: input about 7 cm, output about 10 cm
Construction: integrated shell
Bipolar discharge distance: about 1.5cm (easy to damage beyond)
USES:
Often used in high pressure production, electronic DIY, product development, high voltage electronic security, etc
Method of use
High voltage output end (monochrome thick line) two poles fixed in the specified discharge distance, low voltage input end (two color fine line) red line positive green line negative battery, can produce high voltage arc work.
Input requirements: This product does not need auxiliary circuit, connected to the battery can be directly used, the input terminal is connected to a single 3.7V lithium battery (such as 18650 battery) or nickel cadmium/nickel metal hydride battery pack, 4V or 6V lead-acid battery
Precautions for Use
1. The high voltage module should avoid being powered on when the high voltage is no load. Before powering on, the appropriate distance of the high voltage wire must be adjusted.
The arc distance should be tested from short to long. It is strictly forbidden to exceed the longest arc distance when powering on, because the high pressure energy cannot be released, which is easy to damage the module.
3, the power of the module is large, the internal heat is not suitable, so it can not work for a long time.
4. The way to determine whether the battery capacity can drive the maximum output power is to measure the battery voltage when pulling the arc. If it is around 6V, it can output the maximum power.
5, small capacity of lithium two series for 7.2V, in the state of arc measurement voltage has fallen to about 4V, the smaller the capacity of the voltage is lower. Therefore, it is recommended to use more than 2000MA lithium electricity, and it is best to match more than 4000MA batteries.
